Custom Wrought Iron Gates in the Highlands, Louisville, KY | Custom Gates for Front Walks & Side Passages
Louisville Custom Iron Gates Company builds and installs custom wrought iron gates in the Highlands area of Louisville. Iron gates are very common in the area. The general Highlands area runs deep, narrow lots. It’s very common to only have a few feet between houses, so the work we do in the area is often pedestrian and side-passage scale rather than estate scale. Common new installation projects for homeowners in the Highlands include front entry, garden, and side-passage gates. There’s a good chance you’ve seen our work on Baxter Avenue and in the Cherokee Triangle. Call our team today to schedule your visit and discuss how the new work can fit with your porch rails, fencing, and entrance details. We’ll explain the fabrication and installation proposal, including warranty coverage.
Get a Free Quote in the Highlands
Gate Design on Narrow Highlands Lots
Detail at close range calls for solid stock. Half-inch square bar for pickets, forged collars or dressed welds at the scroll joins, and finial profiles taken off whatever ironwork the house already carries. At three feet away a mould seam on a cast component is obvious in a way it never is on a driveway gate seen from a car.
- Leaf widths set by usable passage, not property lines
- Scroll profiles matched to existing porch railings
- Alley and rear driveway gates built for daily use
- Mid-driveway gate placement so a car can wait off the street
- 1/2" solid square bar for close-range detail
- Restoration of surviving original Highlands ironwork
Highlands Gate Work
- Side passage gates: built to the real gap, with swing direction set by whichever side has clearance.
- Front walk gates: proportioned against the porch and steps rather than the street frontage.
- Alley and rear gates: heavier hinges, two-sided latches, and a positive stop against wind.
- Single-width driveway gates: set back from the pavement so a vehicle has somewhere to sit while it opens.
- Period matching: finial and scroll detail read off the house's own ironwork.
Almost every Highlands job starts with the usable-width measurement. See the full range of gate services we offer.
Alleys, Driveway Placement and Period Detail
A typical Highlands lot leaves only a few feet between the house and the neighbouring property, which limits both the leaf width and the direction a gate can open. The usable passage, not the distance between property pins, is what the gate gets built to.
Many blocks have rear alley access, and driveways are often single-width and run the full depth of the lot. A gate placed mid-driveway rather than at the sidewalk usually gives a vehicle somewhere to sit while the gate opens, which a gate at the street line does not.
Swing vs. Slide Gates on Tight Lots
A sliding gate needs lateral runback, while a swing gate consumes space through an arc. When both are limited, gate width, opening direction and the location of walls, landscaping and parked vehicles become decisive.
Highlands Gate Questions
My side yard is under four feet. Is a gate possible?
Usually yes, but the leaf is built to the usable passage once hinges, post and stop are accounted for, and it may only open one way. That gets measured rather than assumed.
Where should a gate go on a long single-width driveway?
Often several feet in from the pavement rather than at the sidewalk line. That gives a vehicle somewhere to wait off the street while the gate opens.
Can you copy the ironwork on my porch?
That is the usual approach here. Picket spacing, scroll radius and finial profile are taken off the existing railing so the gate reads as part of the house.
Is the Highlands covered by preservation rules?
Parts of Louisville are inside Landmarks districts and parts are not. We will tell you if your address looks like it needs checking before anything is fabricated.